www.catgenie.com
1-888-735-3927
16
CATGENIE TESTING MENU
CAUTION:
Do not run tests unless prompted to do so by CatGenie App or Customer Support
team. Improper use could cause issues with your CatGenie.
Getting Into The Testing Menu:
• Using two fingers, press and hold both Start and Auto buttons at the same time. Hold until the unit speaks.
• Press the Auto button 5x to toggle through options until you hear “Testing Menu.”
• Press Start when CatGenie says “Testing Menu.
"
To toggle through test options 1-8, press the
To toggle through test options 1-8, press the
AUTO BUTTON.
To select the test and navigate through the
To select the test and navigate through the
steps, press the
steps, press the
START BUTTON.
START BUTTON.
1. ARM TEST MODE
– tests the GenieArm movement
When you press the
START
button to test the arm movement, the GenieArm should move down, stop, move up, stop,
and then repeat.
2. BOWL MOTOR TEST MODE
– tests the GenieBowl movement
When you press the
START
button to test the GenieBowl movement, the GenieBowl should move clockwise then stop,
then counterclockwise then stop.
3. WATER FILL TEST MODE*
– tests that the CatGenie is filling correctly.
When you press the
START
button to test the Water Fill Test, you can toggle the test on and off. The unit will add water
and stop at the fill line.
IMPORTANT: You MUST always press Start again to stop the test, even if the water turns
off, before moving on or exiting the Testing Menu. CatGenie will say "Water turned off."
4. SANISOLUTION DOSAGE TEST MODE*
– tests that the Cartridge is depositing SaniSolution.
When you press the
STAR
T button to test the SaniSolution Dosage, you can toggle the test on and off.
IMPORTANT:
You MUST always press Start again to stop SaniSolution flow before moving on or exiting the Testing Menu.
CatGenie will say "Dosage off."
*
CAUTION: The Water Fill Test and SaniSolution Dosage Test should only be conducted when
directed by CatGenie Customer Support. Running these tests alone could damage your unit
and void your warranty.
5. DRAINAGE TEST MODE
– tests the drain pump operation.
When you press the
START
button to test the Drainage Test Mode, you can toggle the test on and off.
6. DRYING TEST MODE
–
tests the heater and fan operation.
When you press the
START
button to test the arm movement, the Dryer should blow cold air, then low, then medium,
then high, then switch off.
CAUTION:
DO NOT leave the area while in Drying Test Mode. Switch it off if you must leave.
7. CAT SENSOR TEST MODE
– tests the GenieEyes
When you press the
START
button to test the GenieEyes, you can toggle the test on and off.
8. FINISHING CYCLE
– starts Finishing Cycle and Exits Testing Menu.
When you press the
START
button to run a finishing cycle, the unit runs a finishing cycle and exits Testing Menu.
ALWAYS run a finishing cycle after running a drainage test.
TO EXIT TESTING MENU
To exit the Testing Menu, press and hold the
To exit the Testing Menu, press and hold the
START
START
Button and the
Button and the
AUTO
Button for 3 seconds then release. The
Button for 3 seconds then release. The
CatGenie will tell you that you have left the Testing Menu. If running a Finishing Cycle, the
CatGenie will tell you that you have left the Testing Menu. If running a Finishing Cycle, the
CatGenie
CatGenie
will exit the
will exit the
Testing Menu automatically when it finishes the cycle. If your CatGenie loses power, it will also automatically
Testing Menu automatically when it finishes the cycle. If your CatGenie loses power, it will also automatically
exit the Testing Menu.
exit the Testing Menu.
