
55
7-4. Item Code(Range : 00 ~99)
The Item Code is used to classify several batching operations.
The Item Code consists of one hundred codes and each code is allotted 7 Set Point values.
Set Point No
I.Code-0
I. Code-1
I. Code-X
I. Code-98
I. Code-99
Set Point-1
S.P(0)-1 S.P(1)-1 S.P(X)-1 S.P(48)-1 S.P(49)-1
Set Point-2
S.P(0)-2 S.P(1)-2 S.P(X)-2 S.P(48)-2 S.P(49)-2
Set Point-3
S.P(0)-3 S.P(1)-3 S.P(X)-3 S.P(48)-3 S.P(49)-3
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
Set Point-6
S.P(0)-6 S.P(1)-6 S.P(X)-6 S.P(48)-6 S.P(49)-6
Set Point-7
S.P(0)-7 S.P(1)-7 S.P(X)-7 S.P(48)-7 S.P(49)-7
Ref. S.P = Set Point, I.CODE = Item Code
The Item Code can be inputted in the two following ways.
▣
The code value can be set in the Weighing Mode by pressing the ENTER key for 2 sec.
DISPLAY
DESCRIPTION
Code=00
Set one of total 100 codes to 00 in batching operation.
Code=99
Set one of total 100 codes to 99 in batching operation.
The changed code is activated by pressing the ENTER key.
The code change is canceled and the code before changed is kept by pressing the “ * ” key.
▣
You can do setting through the RS-232C, RS-485 communication.
(The Command Mode is that the set value of F31 in the Set Mode is set to 4.)
Refer to the Set Mode (page 39,40)
Содержание NT-580A
