3. Avoid any contact with battery acid.
If splashed, immediately
wash affected area with clean water. Continue applying water until
medical help arrives.
4. Do not get the jump cables mixed up.
Connect the black cable to
negative earth on the body of the vehicle, and the red cable to the
positive battery terminal.
5. Only use the jump-start unit in well ventilated rooms or outside in
the open air.
Do not attempt to jump-start the vehicle in the vicinity
of inflammable gases or liquids.
6. Do not allow the black and red clamps to touch.
If this happens it
can melt the clamps or other metal objects. Only connect the clamps
to the corresponding terminals.
7. 12 V systems only.
Only use with vehicles and boats with 12 V
electric systems.
8. For emergency use only.
Do not use this jump-start unit instead of
a vehicle battery. Only use it to jump-start your vehicle.
9. Avoid using the jump-start unit on your own without at least one
other person being present.
If an accident happens, a second
person can get help.
10. Avoid an electric shock.
Be extremely careful with exposed
conductors or busbars. When testing voltages, avoid body contact
with earthed surfaces such as pipes, radiators, kitchen appliances
and housings. Do not put any tools down on the battery since there
might otherwise be the risk of a short circuit! Take off all jewellery
since otherwise there is a risk of a short circuit!
11. Keep working area tidy.
Untidy working areas increase the risk
of injury.
12. Avoid damaging the jump-start unit.
Only use as specified in this
manual.
13. Observe working area conditions.
Do not use the jump-start unit in
damp or wet conditions. Do not expose to rain. Keep work area well lit.
14. Keep children away.
Children are not allowed in the work area. Do
not let them handle machines, equipment, tools or extension leads.
15. Keep idle equipment locked away.
When not in use, keep the
jump-start unit in a dry place to prevent rust. Always keep the
jump-start unit locked away and out of reach of children.
16. Do not expose this jump-start unit
to any direct sunlight, direct
heat or moisture.
17. Wear correct clothing.
Do not wear loose clothing or jewellery
which can be caught up in moving parts. Protective, non-conductive
clothes and non-slip footwear are recommended when working.
Wear protective headgear which can be used to restrain long hair.
18. Do not overreach.
Keep proper footing and balance at all times.
Do not hold onto electrical cables or earth straps. Do not lean over
electrical cables or the vehicle frame.
19. Stay alert.
Pay attention to what you are doing. Be sensible. Do
not use the jump-start unit when you are tired.
20. Do not use the jump-start unit when under the influence of
alcohol or drugs.
Read the warnings on the drug leaflet to check
whether your powers of judgement or reflexes are impaired by
taking the drug. If in any doubt, do not use the jump-start unit.
21. Maintain the jump-start unit with care.
Inspect the cables of the
jump-start unit every time before use. If there is any damage do not use
the jump leads. Repairs may only be carried out by specialists.
22. Check the jump-start unit for damaged parts.
Inspect all parts for damage before using the jump-start unit. Check
the position and connection of moving parts and ascertain whether
any parts or fixtures are broken; check for any other conditions
which could affect correct operation. Damaged parts must be repai-
red or replaced by an authorized technician. Do not use the jump-
start unit if it is damaged or if any of the switches cannot be easily
switched to “on” and “off”.
23. Spare parts and accessories.
During maintenance work, only use
identical spare parts. Use of any other parts makes the warranty null
and void.
Instruction manual
6
Important
Please read through the operating instructions before using the
Power Station. Look after these instructions properly. If you pass on
the device to a third party, pass on all the documents to them too.
Before using the Power Station Plus for the first time, check in your
vehicle’s manual whether external starting is permitted.
Safety warnings and precautions Warnings:
When using the jump-start unit, always take basic safety
precautions to reduce the risk of personal injury and damage to
equipment.
No liability whatsoever is accepted for loss or damage or con-
sequential loss in the event of failure to observe these operating
instructions, in particular in the event of conversion or modification
of the device. In such cases, warranty claims lapse. Use the device
only with the accessories supplied with it and only for its intended
purpose.
Read all instructions thoroughly before using this jump-start
unit!
Do not expose the Power Station to high (>25°C) or very low (<3°C)
temperatures, strong vibrations or moisture.
1. Wear safety goggles.
When working on or in the vicinity of a
lead battery, always wear safety goggles to the ANSI standard.
2. Wear hearing protection.
Always wear hearing protection
when working with the Power Station/compressor.
Items
Description
Battery type
gas-tight, lithium-ion rechargeable
Jump-start unit
400 A (600 A peak)
Compressor
12 V / 18 bar
Weight
2,3 kg
Cable
fully insulated copper cable
Work light
LED
Output socket
12 VDC
Features
Safety switch
Overload protection
Overcharging protection
12 VDC cigarette lighter socket
Valve adapter kit
1
On/off safety dial
2
12 Volt output
3
LED light
4
Battery condition indicator
5
Charge status indicator
6
Charging socket
7
Circuit breaker
8
Battery condition indicator button
9
On/off switch for light
10
Housing
11
Red (positive) terminal clamp
12
Black (negative) terminal clamp
13
12 Volt charging cable
14
230 Volt charging cable
A.
On/off switch, compressor
B.
Pressure gauge
C.
Valve connection
D.
3 adapters
GB
77955-AZ-Profi-Powerstation-12V-CTR-IM-INT-OEF-170824.indd 5
24.08.17 10:24
