Carter Talon 150 DLX Series, Руководство по обслуживанию

Страница: 21 / 81

17
CAMSHAFT INSTALLATION
• Rotate the flywheel to align the “T” mark on the flywheel with the camshaft mark. The round hole
on the cam chain wheel should be up, and the left and right sit parallel with the cylinder head (the
lobes of the camshaft are down). Then install the camshaft on the cylinder head.
• Mount the cam chain on the chain wheel.
• Install the dowel pins.
• Mount the camshaft holder, washer and bolt cap on the cylinder head.
• Tighten the cylinder head bolt and nut.
• Turn the cam chain tensioner adjusting bolt counter-clockwise,
and release the lock.
• Apply oil on the new O-ring.
• Mount and tighten the cam chain tensioner cover bolt.
• Replace the valve cover gasket, and mount the cover.
• Tighten the valve cover-positioning bolt.
ROCKER ARM AND ROCKSHAFT
ROCKER ARM AND ROCKSHAFT REMOVAL
• Remove the camshaft holder.
• Take out the rockshaft by removing the bolt.
• Remove the rocker arm.
ROCKER ARM AND ROCKSHAFT INSPECTION
Inspect if there is any abrasion or damage on the rocker arm and rockshaft or if the oil hole is
clogged.
While installing, apply some oil on the thread of the camshaft holder
bolt. The camshaft nuts should be tightened diagonally in a 3-step
process. After installing, adjust the valve clearance.
The O-ring must be mounted properly in the groove.
The valve cover gasket must be properly mounted in the groove.
If there is abrasion on the surface of the rocker arm, the camshaft should also be inspected.