Carter Talon 150 DLX Series, Руководство по обслуживанию

Страница: 15 / 81

11
PISTON RINGS SET UP
Before setting up, apply oil on each piston ring, then enlarge piston rings; at the same
time put them on the piston and move downwards gradually, until piston rings fall into the
ring groove.
PISTON SET INSTALLATION
• Remove the gasket attached to the crankcase.
• Mount piston onto the small end of the connecting rod.
• Mount piston pin and piston pin clip
• Apply oil on the piston pin to lubricate it.
CRANK CONNECTING ROD SET
The connecting rod is the component that links the piston and crank.
The picture shows the structure and assembling relations of the crank
connecting rod component.
CRANKCASE AND CRANKSHAFT REMOVAL
Before removing the crankcase and crankshaft, follow these procedures:
• Remove the engine.
• Remove the cylinder cover.
• Remove the cylinder.
• Remove the piston.
• Remove the drive plate and the driven plate.
• Remove the AC generator.
• Remove the starting motor.
• Remove the oil pump.
• Then remove the cam chain tensioner bolt. Remove the
cam chain tensioner.
• Use special tools to remove the starting driven gear.
The top of the piston marked with “IN” should be mounted towards the direction of
the inlet port (if the mark is “EX”, then it should be mounted towards the direction of
the exhaust port).
Cover the crankcase port with a piece of cloth to keep the
piston clip from dropping into the crankcase.