Carrier WeatherMaker 48TC 04 Скачать руководство пользователя

Страница: 2 / 60

fire extinguisher available. Read these instructions thoroughly

and follow all warnings or cautions attached to the unit.

Consult local building codes and appropriate national electrical

codes (in USA, ANSI/NFPA70, National Electrical Code

(NEC); in Canada, CSA C22.1) for special requirements.

It is important to recognize safety information. This is the

safety-alert symbol

. When you see this symbol on the unit

and in instructions or manuals, be alert to the potential for per-

sonal injury.

Understand the signal words DANGER, WARNING, CAU-

TION, and NOTE. These words are used with the safety-alert

symbol. DANGER identifies the most serious hazards which

will result in severe personal injury or death. WARNING signi-

fies hazards which could result in personal injury or death.

CAUTION is used to identify unsafe practices, which may re-

sult in minor personal injury or product and property damage.

NOTE is used to highlight suggestions which will result in en-

hanced installation, reliability, or operation.

Rated Indoor Airflow (cfm) —

Table 1 lists the rated

indoor airflow used for the AHRI efficiency rating for the units

covered in this document.

Table 1 — AHRI Efficiency — Rated Indoor Airflow

WARNING

Failure to follow this warning could result in personal

injury or death. Disconnect gas piping from unit when leak

testing at pressure greater than 0.5 psig (3450 Pa). Pres-

sures greater than 0.5 psig (3450 Pa) will cause gas valve

damage resulting in hazardous condition. If gas valve is

subjected to pressure greater than 0.5 psig (3450 Pa), it

must be replaced before use. When pressure testing field-

supplied gas piping at pressures of 0.5 psig (3450 Pa) or

less, a unit connected to such piping must be isolated by

closing the manual gas valve.

WARNING

Failure to follow this warning could cause personal injury

or death. Before performing service or maintenance opera-

tions on unit, always turn off main power switch to unit and

install lock(s) and lockout tag(s). Unit may have more than

one power switch.

WARNING

Failure to follow this warning could cause personal injury,

death and/or equipment damage.
Puron (R-410A) refrigerant systems operate at higher pres-

sures than standard R-22 systems. Do not use R-22 service

equipment or components on Puron refrigerant equipment.

WARNING

Failure to follow this warning could cause personal injury

or death.
Relieve pressure and recover all refrigerant before system

repair or final unit disposal.
Wear safety glasses and gloves when handling refrigerants.

Keep torches and other ignition sources away from refrig-

erants and oils.

CAUTION

Failure to follow this caution may result in personal in-

jury. Sheet metal parts may have sharp edges or burrs.

Use care and wear appropriate protective clothing, safe-

ty glasses and gloves when handling parts and servicing

air conditioning equipment.

WARNING

CARBON-MONOXIDE POISONING HAZARD
Failure to follow instructions could result in severe person-
al injury of death due to carbon-monoxide poisoning, if

combustion products infiltrate into the building.
Check that all openings in the outside wall around the vent

(and air intake) pipe(s) are sealed to prevent infiltration of
combustion products into the building.
Check that furnace vent (and air intake) terminal(s) are not

obstructed in any way during all seasons.

WARNING

FIRE HAZARD
Failure to follow this warning could result in personal

injury, death, and/or property damage.
Inlet pressure tap set screw must be tightened and

in. NPT

pipe plug must be installed to prevent gas leaks.

WARNING

FIRE HAZARD
Failure to follow this warning could result in personal

injury, death, and/or property damage.
Manifold pressure tap set screw must be tightened and

in. NPT pipe plug must be installed to prevent gas leaks.

MODEL NUMBER

FULL LOAD AIRFLOW (CFM)