Carrier VVT Bypass II, Руководство по установке и запуску

Страница: 23 / 52

Installing the VVT Bypass II
VVT Bypass II Controller CARRIER CORPORATION ©2019
Installation and Start-up Guide All rights reserved
19
Linked actuators
You can wire up to 4 of the following Belimo actuators to the VVT Bypass II's analog output. Link actuators
whose travel times and other parameters coincide.
LMX24-MFT P-10028
45 in.-lb (5 Nm) actuator with 0–10 Vdc control
NMX24-MFT P-10028 90 in.-lb (10 Nm) actuator with 0–10 Vdc control
AMX24-MFT P-10028 180 in.-lb (20 Nm) actuator with 0–10 Vdc control
1
Install the actuators according to the manufacturer's instructions.
2
Wire the actuators to the controller using the diagram below.
3
Set the direction rotation switch on each actuator to CW.
NOTE Maintain polarity if using the same power supply for more than one actuator.