Carrier VVT Bypass II, Руководство по установке и запуску

Страница: 21 / 52

Installing the VVT Bypass II
VVT Bypass II Controller CARRIER CORPORATION ©2019
Installation and Start-up Guide All rights reserved
17
To wire and mount the DAT sensor
1
Wire the sensor to the controller. See diagram below.
NOTE Sensor wiring does not have polarity. The wires can be connected to either terminal.
2
Using electrical tape, insulate any exposed wire to prevent shorting.
Wiring field-supplied actuators to the analog output
You can wire a high-torque actuator or parallel actuators to the controller's 0–10 Vdc analog output.
NOTE You cannot use the VVT Bypass II's actuator if wiring external actuator(s) to the analog output.