Carrier VVT Bypass II, Руководство по установке и запуску

Страница: 22 / 52

Installing the VVT Bypass II
VVT Bypass II Controller CARRIER CORPORATION ©2019
Installation and Start-up Guide All rights reserved
18
High-torque actuators
You can wire one of the following Belimo actuators to the VVT Bypass II's analog output instead of using the
controller's 45 in.-lb (5 Nm) actuator.
NMX24-MFT P-10028
90 in.-lb (10 Nm) actuator with 0–10 Vdc control and 0–10 Vdc
feedback
AMX24-MFT P-10028 180 in.-lb (20 Nm) actuator with 0–10 Vdc control and 0–10 Vdc
feedback
1
Install the actuator according to the manufacturer's instructions.
2
Wire the actuator to the controller using the diagram below.
NOTE For proper operation and to prevent damage to the devices, use the same polarity for the actuator's
power and the VVT Bypass II's power.