Carrier TruVu UCXP683T-V, Руководство по установке и запуску

Страница: 39 / 76

Adjusting the TV-UCXP683T-V driver properties
TruVu™ UCXP683T -V CARRIER CORPORATION ©2021
Installation and Start-up Guide All rights reserved
35
After you find and upload the TV-UCXP683T-V in the i-Vu® interface, you may want to customize the TV-UCXP683T-
V's settings for your applications. You can change settings on the Driver Properties page.
1
In the i-Vu® interface, right-click the TV-UCXP683T-V in the navigation tree and select Driver Properties .
2
Adjust the driver as desired.
Driver
The Driver page provides the following information plus the items described in the table below:
•
The date/time of last parameter change or the last time the database was archived
•
If control programs, properties, and schedules were successfully stored in memory
•
Undelivered Alarm Status
TouchScreen Control
TouchScreen Schedule Edit
Enable
Check this field to allow a user to edit this controller's schedules from an
Equipment Touch or System Touch Schedules screen.
NOTE Schedules edited on an Equipment Touch or System Touch are not
uploaded to the i-Vu® application. This could result in the controller operating on
a schedule that differs from the one you see in the i-Vu® interface.
Controller Clock
Clock Fail Date and Time Date and time the controller uses when its real-time clock is invalid.
Time Synch Sensitivity
(seconds)
When the controller receives a time sync request, if the difference between the
controller's time and the time sync's time is greater than this field's value, the
controller's time is immediately changed. If the difference is less than this field's
value, the controller's time is slowly adjusted until the time is correct.
Network Microblocks
BACnet third party
integration points capacity ,
integration points requested ,
and integration points active
Shows how many third-party BACnet points the TV-UCXP683T-V allows (capacity),
how many points are in the control program (requested), and how many are
currently active (not disabled in i-Vu®).
For example, if the controller allows 400 points, the control program has 350
points, and you disabled 30 points in i-Vu®, you would see:
Integration points capacity: 400
Integration points requested: 350
Integration points active: 320
Modbus integration points
capacity
and integration
points active
Shows how many Modbus points the TV-UCXP683T-V allows (capacity) and how
many are currently active.
Number of poll retries before
Network Input Microblocks
indicate failure
The maximum number of retries after the initial attempt that a Network
microblock will attempt to communicate with its target device. If unsuccessful, the
point will transition to an idle state for 30 seconds before attempting to
communicate again. Change this field only if directed by Technical Support.
Adjusting the TV-UCXP683T-V driver properties