Carrier OPN-VVTZC, Руководство по установке и запуску

Страница: 33 / 80

VVT Zone Controller 29
To start up the VVT Zone Controller, you need one of the following user interfaces. These items let you access
the controller information, read sensor values, and test the controller.
This interface... Provides a...
i-Vu Open Permanent interface software
Field Assistant software -
runs on a laptop connected to controller's Local Access port
Temporary interface
1
Virtual BACview software -
runs on a laptop connected to controller's Local Access port
Temporary interface
1, 2
BACview6 Handheld keypad/display unit -
connects to controller's Local Access port
Temporary interface
1, 2
BACview6 keypad/display unit
connected to controller's Rnet port
Permanent interface
2
1 Requires a USB Link (USB-L).
2 See the BACview Installation and User Guide for instructions on connecting and using the above items.
Configuring the VVT Zone Controller's properties
To start up the VVT Zone Controller, you need to configure the properties described in the following sections.
These properties affect the unit operation and/or control. Review and understand the meaning and purpose
of each property before changing it.
•
Unit Configuration properties 30 (page )
• Setpoint Configuration properties 30 (page )
•
Service Configuration properties 33 (page )
• Linkage properties
34 (page )
See Appendix A (page 51) for a complete list of the controller's points/properties.
NOTE Engineering units shown in this document in the defaults and ranges are strictly for reference. You
must enter an integer only.
Start-up