Carrier 39HXC, Руководство пользователя, Страница: 32 / 64

4.4.2 - Modifying the HMI LCD terminal addresses
It is only possible to modify the address of the terminal when it is connected to the controller (telephone connector) and
when the controller is powered on.
-
To enter configuration mode, simultaneously press the

and buttons, holding for at least 5 seconds; the page shown opposite
will be displayed, with the cursor flashing in the top left corner
-
To modify the terminal's address (Display address setting) press the button once: the cursor will move to the address field (nn)
-
Select the desired value using the

buttons, and confirm by pressing the button again
If the value selected is different from that previously stored in the memory, the page shown below will appear and the new value will
be stored in the terminal's permanent memory.
Please note: if you need to change the address of a controller using a terminal, you may only do so with a terminal with the
address 0.
After having changed the controller address, remember to change the terminal address from 0 to a different value to ensure
normal operation.
4.4.3 - Modifying the controller addresses
The value of the factory-set address is '1'. The controller pLAN address can be modified, if the controller needs to be networked.
Directly from the controller
To modify the address, it is necessary to use a screwdriver and to follow the procedure below:
-
Press the button for 5 seconds: the address should flash
-
Press the button several times or press and hold until the desired address is obtained
-
Wait for the address to flash rapidly
-
The address is now saved
-
Disconnect then reconnect the controller (powering off confirms the change)
4 - MANAGING THE CONNECTION BETWEEN CONTROLLERS AND
ALPHANUMERIC TERMINALS
32