Carrier TRANSICOLD VECTOR 8100, Руководство по эксплуатации и обслуживанию, Страница: 53 / 294

3–3 62-11785
3.3 STARTING UNIT
1. Place the START/RUN-OFF switch in the START/RUN position.
2. The system will display the Carrier Transicold logo, display the default screen, present language selection
and the hour meter readings (if configured to do so) along with a test flash of the alarm light and light bar
amber LED’s. The system will then perform a start sequence, energize the buzzer, and then start the unit
automatically.
NOTE
If the unit attempts to start and power is not available, alarm 00073 NO POWER-CHECK POWER
CORD will be activated. This alarm will clear if power is restored.
3. If there is an alarm present, the alarm message will be displayed in the MessageCenter and the alarm LED
will flash for 5 seconds. If one or more shutdown alarms are present, the alarm(s) must be cleared before
the unit will start.
4. Once the unit is operating observe the MessageCenter. If the word “ACTIVE” or “MODIFIED” is displayed at
the right, the unit is equipped with IntelliSet settings, refer to Section 3.5 .
5. If the LCD Display does not illuminate, check:
• Battery voltage. A booster battery may be needed.
• Check for blown fuse(s).
• Verify the harness connector at the back of the display module and all other module connectors are
securely attached.
1
START/STOP ELECTRIC COOL
BOX TEMPERATURE
o
F SETPOINT
o
F
STATUS OK
34
.3 34
3
4