Carrier TRANSICOLD VECTOR 8100, Руководство по эксплуатации и обслуживанию, Страница: 121 / 294

5–23 62-11785
S/S PARAMETERS TOGETHER
SEPARATE
TOGETHER = When the Minimum Run Time,
Minimum Off Time, Restart Temperature,
Maximum Off Time, and Override Temperatures
are set in the Functional Parameter List, the same
values will be used for both Frozen and Perishable
setpoints.
SEPARATE = When the Minimum Run Time,
Minimum Off Time, Restart Temperature,
Maximum Off Time, and Override Temperatures
are set in the Functional Parameter List, different
values may be entered for Perishable and Frozen
setpoints.
INTELLISET & PRODUCTSHIELD
ENABLE INTELLISET AT = KEY NO
YES
YES = Allows access to the IntelliSet menu using
the = key.
NO = Allows access to the IntelliSet menu using the
SELECT key.
PRODUCTSHIELD: ECONO OFF
GO TO S/S
GO TO CONT
OFF = ProductShield Econo is OFF
GO TO START/STOP = Allows unit to be set for
and operate in Continuous Run until ambient
temperature falls
within a user-defined range when
unit will go to START/STOP. This allows energy
savings while offering Continuous Run operation
protection when ambient is outside range. Unit will
return to Continuous Run when ambient goes
beyond range.
GO TO CONTINUOUS = Allows unit to be set for
and operate in START/STOP until ambient
temperature falls
outside a user-defined range
when unit will go to Continuous Run. This provides
continuous air flow and good product protection for
extreme ambient temperatures. Unit will return to
START/STOP when ambient comes back inside
range.
ECONO MIN. TEMP OFF
-20°F to +119.0°F (-
28.9°C to
+48.4°C) (in 0.5°
increments)
Default: 119.0°F (48.4°C)
OFF = There is no lower limit for this parameter.
Select the lowest ambient temperature desired to
activate ProductShield Econo.
If ProductShield Econo is Go To Continuous there
is a minimum 10°F range. Therefore, this
parameter’s upper limit is ProductShield Econo
Maximum Temperature minus 10°F (5.5°C).
Table 5–1 Configuration Settings
(Refer to Section 5.2.3 for instructions on entering Configuration settings)
Configuration Selections Description