Carl Valentin FLEXICODE 53, Руководство по эксплуатации

Страница: 58 / 120

Function Menu Flexicode
58 Operating Manual 11.19
7.8 Ribbon Save (Continuous Mode)
Switch on the control unit and the display shows the main menu.
Press the key to access the function menu.
Press the key until the menu Ribbon save is displayed.
Press the key to select the menu.
Press the keys and to select the ribbon save mode 'Standard'.
Standard Maximum ribbon save performance, i.e. with this setting
there is no loss of transfer ribbon (apart from the safety
distance of 1 mm, so the print fields are not printed one
into the other).
No settings are allowed with which the ribbon save no
more cannot be achieved. This particularly applies for
the print offset, which can only be adjusted now in the
valid range.
Press the key to move to the next menu item.
Determination of max. print speed.
On the base of this value all necessary calculations e.g. feedback
distance and smallest possible print offset are being calculated.
Example
Speed = 400
Mode = Standard Very good ribbon save result between
50 mm/s
… 400 mm/s.
However, if you print with a speed higher than 400 mm/s, then the
ribbon save result is decreased and/or the ribbon save can no longer
be executed, because the back-feed way was designed to 400 mm/s.
Please consider: if speed is set to 400 and only 300 mm/s are printed,
then a smaller number of cycles is reached as if speed is set to 300,
however a reserve of 100 mm/s is still available.
Therefore the speed value should be always set to the maximum print
speed. If the number of cycles is not sufficient, the rewind correction
should be applied.
Press the key to move to the next menu item.
TR Correction
0 mm
= It is always so far retracted that an optimal ribbon save is
reached (no loss of transfer ribbon). This is rather rarely realised, as
the ribbon position can deviate because of inaccuracies at speed
measurement (encoder).
Default: -1 mm
Mode
Speed
Transfer ribbon
correction