Ribbon Save / Foil Saving
Dynacode II Series
110
Operating Manual
08.16
15.2 Standard Ribbon Save (Continuous Mode)
Select ribbon save mode
Standard
.
0 mm
= It is always so far retracted that an optimal ribbon save is
reached (no loss of transfer ribbon). This is rather rarely realised, as
the ribbon position can deviate because of inaccuracies at speed
measurement (encoder).
Default: -1 mm
−
xx mm
= The feedback can be made smaller. It causes loss of
transfer ribbon but the number of cycles is increased. If the value is
increased to the complete backfeed length then the direct print
module sets automatically the max. value and no more backfeed is
accomplished.
+xx mm
= The feedback can be made larger. This causes that it is
printed onto the transfer ribbon in the previous printout.
W W
W W
W W
W W
sa/mm:
The smallest possible distance of two prints with full ribbon
save (the print offset must be set to the minimum value). As basis for
the calculation the set ribbon save parameters are used, as well as
mode and especially the indicated max. print speed.
cmin:
Max. number of cycles per minute.
so/mm:
Indicates the loss of ribbon save, i.e. how many mm transfer
ribbon is effectively lost.
Ribbon save mode
Return correction
Example
Performance
information
