_________________________________________________________________________________________________________________________
Card Access Sensor Bridge
Page 7 of 12
Quick Start & Installation Guide
Card Access, Inc.
BUS LED:
GREEN (solid)
Bridge is connected to Control4 automation system and operating
properly (ZigBee connection established, driver properly identified)
RED (solid)
ZigBee PRO
: Bridge is not connected to the ZigBee mesh.
RED (short winks OFF)
ZigBee PRO
: Bridge is connected to the ZigBee mesh but is not
communicating with the ZGB10A driver. Ensure bridge has been
identified into the system.
EmberNet:
Bridge is not communicating with the ZGB10A driver.
Ensure bridge has been identified into the system.
NOTE
:
The Sensor Bridge and its associated drivers provide a good deal of diagnostic
information to assist in deployment of Sensor Bridges as well as placement and testing of
wireless sensors. The information below is also included in the
Documentation
tab of
each driver.
ZGB10A Driver Details
•
Supported Devices:
o
First Card Access Sensor Bridge in a project
-
Model Number. ZGB10A
•
Properties Page Help:
o
Bridge Status
: Displayed as “Online” or “Offline.” NOTE: if the
Sensor Bridge is offline, all sensors will register as offline.
o
Last Check-In:
Shows the last check-in date and time of the
Sensor Bridge.
o
Last Event:
Shows the date and time of the last sensor event,
along with the TxID or name of the sensor and the signal level.
ZGB10A-XP Driver Details
•
Supported Devices:
o
Additional Card Access Sensor Bridges in the same project
-
Model Number. ZGB10A
•
Properties Page Help:
o
To view diagnostic information on Expansion Bridges, refer to
the properties page of the primary Sensor Bridge ZGB10A
driver.
