_________________________________________________________________________________________________________________________
Card Access Sensor Bridge
Page 10 of 12
Quick Start & Installation Guide
Card Access, Inc.
Smoke Detector Driver Details
•
Supported Devices:
o
GE Supervised Wireless Smoke Detector
-
Card Access Model Number: GSD10A
-
GE Model Number: TX-6010-01-1
NOTE:
This driver MUST be used in conjunction with the Card
Access Sensor Bridge hardware and DriverWorks driver. GE
Wireless Sensors do NOT need to be associated in any way with a
specific Sensor Bridge in Composer.
•
Properties Page Help
:
o
Sensor TxID:
Enter the TxID printed on the Sensor Label.
The TxID is a 6 or 7-digit alphanumeric address.
o
Sensor Name:
An optional descriptive name may be entered
here. This name is displayed on the property page of the
Bridge when data for this sensor is received.
o
Alarm Contact State:
shows the current state of the alarm as
"Alarm" (meaning smoke is detected) or "No Alarm"
(meaning no smoke has been detected).
o
Sensor Status:
shows whether the sensor as "Online" or
"Offline." This status is affected by the connection state of
the Sensor Bridge(s).
o
Last Sensor Event
: shows the date and time of the last event
received, as well as the contact status and low-battery
status.
o
Last Signal Level:
shows the approximate signal level of the
last received event. Use this level to aid in proper positioning
of sensors.
o
Supervisory Timeout
: sets the number of supervisory periods which must be missed before the “Supervisory
Lost” event is triggered. Supervisory periods for these sensors are every 64 minutes.
o
Supervisory State:
shows current state of the supervisory signal monitor.
o
Statistics:
shows the number of events and RX success of the sensor.
•
Actions Page Help:
•
Identify Sensor:
Click this button to allow the driver to automatically 'learn' the TxID of the sensor. After clicking
the button, activate the 'Tamper' signal on the smoke detector by separating the unit from the mounting base.
When the sensor has been successfully identified, the TxID will appear in the Sensor TxID field of the Driver
Properties page.
•
Cancel Identify
: Click this button to abort the sensor identify process. Note that clicking this button is not
necessary if you have successfully identified a sensor.
