Carbatec BS-345C, Инструкция по эксплуатации

Страница: 17 / 36

CARBATEC.C OM.AU
17
BS-345C
D. TABLE SETUP
1.
Place the table insert back in position,
taking care to align the insert notches.
Insert the table pin and firmly seat with a
small hammer tap. Fig. D1
2.
Tilt the table up to roughly 30° to 40°, or
enough to insert the 90° table stop bolt.
Thread the stop bolt into the threaded
hole, with the nut above the bracket.
Fig. D2 Thread the bolt in until you can
lower the table to 90°. The nut will need
adjustment as you go to achieve this.
3.
Place a square on the table up against
the blade. Now adjust the tilt of the table
until you have an accurate 90° table to
blade angle. Lock the table in place by
tightening the two trunnion tilt knobs.
Fig. D3
4.
Loosen the scale arrow marker on the
front trunnion with a Philips Head screw
driver and realign for zero if required,
then re-tighten. This scale is a guide
only; for accurate angle cutting, a
digital angle finder (sold separately) is
recommended.
5.
Finally, with the table secured at 90°,
‘unwind’ the stop bolt below the table
until the head sits firmly against the
underside. Then tighten the loose nut
down against the bracket wit a 14 mm
spanner to lock the stop in place. You
now have a 90° reference to return to
should you ever tilt the table.
MACHINE SETUP
Fig. C
Fig. D1
Fig. D2
Fig. D3
MACHINE SETUP