Carbatec BS-345C, Инструкция по эксплуатации

Страница: 18 / 36

FOR TECHNICAL SUPPORT CALL
1800 658 111
18
BS-345C
MACHINE SETUP
E. INSTALLING AND SETTING
UP THE RIP FENCE
1.
Mount the front fence rail to the table
using two hex head bolts (M6 x 20) and
two spring washers. A 10 mm spanner
is required. Leave the bolts just a little
loose for now. Fig. E1
2.
The fence handle can be screwed into
place on the fence glide body, then
lowered into position on the front fence
rail. The nut is used to lock the handle
into place, preventing it coming loose
during use. Fig. E2
3.
The fence itself, when positioned
properly in the rail, should sit marginally
above the table surface. Adjust as
required, ensuring it is even on both
sides then tighten the front rail home
to the table. As these are slotted holes,
aligning your bolts to the center will
allow some adjustment either way later,
if required.
4.
The square tube rear rail can now be
installed with the two Allen head bolts,
ensuring you orient it so the excess rail
hangs over the table toward the machine
frame. Tighten the bolts home.
5.
Now install the rear fence glide foot.
Remove the fence end cap with a
screwdriver. Remove the nut from the
foot bolt and screw the threaded foot
bolt into the hole on the underside of
the fence. Adjust the height of the foot
so the fence sits just above the table, as
per the front. When done, screw the foot
nut into place inside the fence to lock
the position, then screw the fence cap
back into place. Fig. E3
Fig. C
Fig. E1
Fig. E2
Fig. E3