Carbatec BS-345C, Инструкция по эксплуатации

Страница: 21 / 36

CARBATEC.C OM.AU
21
BS-345C ADJUSTMENTS
Fig. C
Fig. I1
Fig. I3
Fig. I2
Depth Lock Knob
Thrust Lock Knob
Adjustment
I. BLADE BEARING GUIDE
ADJUSTMENT
1.
The bearing guide systems found on this
machine are fully adjustable. Working
from the side, release the depth lock
knob and rotate the threaded adjuster,
until the bearing sits approx. 2mm behind
the set of the teeth on the blade. Fig. I1
2.
Release the thrust bearing lock on
the back side of the guide and set the
Thrust Bearing so it sits just behind (no
more than 1mm) the back of the blade.
3.
The dual bearings’ sideways adjustment
is via an off-centre cam. Release the
allen head locking bolt then ‘swing’
the bearings in or out by rotating from
the front. Bring each side in until it just
barely misses the blade, like a piece of
paper thickness away. Fig. I2
4.
The lower bearing guides are less
accessible, but need to be set as per
the top guides. There are lock knobs
and adjustments for the thrust bearing
behind the blade; the side bearings
depth setting; and the side bearings
pivot adjustment. Hint: Opening the
lower door and removing the table insert
will provide more visibility when setting
the lower blade guides. Try your mobile
phone’s torch ability placed on the
table and illuminating through the insert
hole. Once set, ensure you retighten
everything. If done correctly, you should
not need to adjust this unless you
change blades. Fig. I3
Thrust Bearing
and Adjuster
Depth Lock Knob
Adjustment