Carbatec BS-345C, Инструкция по эксплуатации

Страница: 10 / 36

FOR TECHNICAL SUPPORT CALL
1800 658 111
10
BS-345C
BANDSAW SAFETY
INTENDED USE
• The machine must only be used in
technically perfect condition in accordance
with its designated use and the instructions
set out in the operating manual, and
only by safety-conscious persons who
are fully aware of the risks involved in
operating the machine. Any functional
disorders, especially those affecting the
safety of the machine, should therefore
be rectified immediately. The safety, work
and maintenance instructions of the
manufacturer as well as the technical data
given in the calibrations and dimensions
must be adhered to.
• Relevant accident prevention regulations
and other, generally recognised safety-
technical rules must also be adhered to.
• The machine may only be used, maintained,
and operated by persons familiar with it and
instructed in its operation and procedures.
Arbitrary alterations to the machine release
the manufacturer from all responsibility for
any resulting damages.
• The machine may only be used with original
accessories and tools made
by or recommended by the manufacturer
• Any other use exceeds authorisation.
The manufacturer is not responsible
for any damages resulting from unauthorized
use; risk is the sole responsibility of the
operator.
SAFETY FOR BANDSAWS
• This bandsaw is intended for use in dry
conditions, and for indoor use only.
• Do not cut pieces of material too small
to hold by hand outside the blade guard.
• Avoid awkward hand positions where
a sudden slip could cause a hand to move
into the blade.
• Always use the blade guard to avoid
possible injury due to blade breakage.
• Never leave the work area with the power
connected, or before the machine has come
to a complete stop.
• Do not perform layout, assembly or set
up work on the table while the cutting tool is
in operation.
• Never turn your bandsaw on before clearing
the table of all objects: (tools, scraps of
wood, etc) except for the workpiece and
related feed or support devices for the
operation planned.
REMAINING HAZARDS
The machine has been built using modern
technology in accordance with recognised safety
rules. Some remaining hazards, however, may
still exist.
• Long hair and loose clothing can be
hazardous. Wear personal protective gear
such as a hair net and tight fitting
work clothes.
• Saw dust and wood chips can be hazardous.
Always wear AS/NZS approved personal
protective gear such as safety goggles, dust
mask and hearing protection.
• The use of incorrect or damaged mains
cables can lead to injuries caused
by electricity.
• Even when all safety measures are taken,
some remaining hazards which are not yet
evident may still be present.
• Remaining hazards can be minimised
by following the instructions in Safety
Precautions, Proper Use and
in the entire operating manual.
• Do not force the machine unnecessarily:
excessive cutting pressure may lead to rapid
deterioration of the blade and a decrease in
performance in terms of finish and
cutting precision.