Canton Smart Vento 9, Руководство по эксплуатации

Страница: 77 / 106

3 79
English
7
Now plug only the desired slave speaker into the power outlet and switch it on using the power switch�
Important:
Before, the slave must have been disconnected from the mains for at least 30 seconds�
8
If the speaker is in standby, turn it on by pressing the power button on the remote control�
Important:
The maximum time between pressing the “OK” button and switching on the slave speaker is 30 seconds�
9
Approx� 10 – 20 seconds after switching on the slave speaker the displays should show CON�
If FAI appears in the display, repeat above steps and make sure that
a� the desired slave was disconnected from the mains for at least 30 seconds�
b� no more than 30 seconds have passed between pressing the “OK” button and switching on the slave speaker�
c� the distance between the two speakers may not exceed 10 m and they are in the same room�
Attention!
Should you have performed the above steps, never repeat them with the master speaker switched off,
as this will automatically designate a new master speaker and would prevent the previous slave speakers from connecting
to the previously designated master speaker�
BT (Bluetooth ® Menu)
Press the “M” button, SPS is displayed� Now press the “ ” button until WIS appears in the display�
Press the “OK” button and use the navigation keys “ ” and “ ” to select BT and press “OK”�
BTP (Bluetooth ® Pairing)
This menu allows you to set whether the speaker sends a pairing request to mobile devices permanently
or whether this is to be done manually via the Bluetooth
®
paring button�
To change the way in which the paring is done, proceed as follows:
1
Select the Bluetooth
®
menu according to the BT (Bluetooth
®
Menu) chapter and select the BTP function using the navigation buttons “ ” and “ ”.
2
Change the value using the “+/–” buttons�
AUT= Device transmits permanently�
MAN= Request is activated by pressing the Bluetooth
®
pairing button�