MAPMINI
Page 19 of 28
Installation Manual
September 2021 • Rev. 1.4
POWER CONNECTOR
SHUTDN – SHUTDOWN BUTTON
As the MAPMINI contains a mini computer, a proper system shutdown is nesscessary
to prevent data corruption.
DO NOT simply unplug the power connector.
To shut
down follow this procedure:
1.
Press and hold (4 to 8 seconds) the
SHUTDN button until the status
SHDN LED near the SHUTDN
button begins a rapid green
ON/OFF flash then release the
pushbutton. The system will start a
proper shutdown. This will take 15
to 20 seconds.
2.
Wait untill the status SHDN LED (except power) and the reader LEDs are off
with a single beep from the controller then remove the power connector.
3.
If the shutdown does not occur, try the procedure again. If it still does not
respond correctly as described above, a system fault has occurred. It will be
necessary to unplug the power connector and re-insert it after 10 seconds.
Figure 14
Figure 15
