Expand Serial Command Specification
Page 21 of 46
8.5.9. CF_ORGMODE Command
Command “CF_ORGMODE_%1” [CR]
%1
“XGA1”, “HDTV1080” … etc.
Details
After EXTn is set by PC Control series Command and CF_SETPCADJ
Command such as CF_FSYNC / CF_TDOTS, this Command select original
signal. (Only valid when it is in the usual Power On state)
Acceptable
“000” [CR]
Response
Unacceptable “101” [CR] ---- When Input is Video series
8.5.10. CF_PCSTORE Command
Command “CF_PCSTORE_%1” [CR]
%1
“MODE1” --------- Store current PC Adjust status to MODE 1
“MODE2” --------- Store current PC Adjust status to MODE 2
“MODE3” --------- Store current PC Adjust status to MODE 3
“MODE4” --------- Store current PC Adjust status to MODE 4
“MODE5” --------- Store current PC Adjust status to MODE 5
Details
Store current PC Adjust status (each parameter status such as Total dots) to
Mode1~5.
This command operates the same operation as storing to Mode1~Mode5 in PC
Adjust Menu. (Only valid when it is in the usual Power On state)
Acceptable
“000” [CR]
Response
Unacceptable “101” [CR] ---- When Input is Video series
8.6. Input Control Command
8.6.1. CF_INPUT Command
Command “CF_INPUT_%1” [CR]
%1
“1” --------------- Select Input-1
“2” --------------- Select Input-2
“3” --------------- Select Input-3
“4” --------------- Select Input-4 (Network Viewer)
Details
Select Input. (Only valid when it is in the usual Power On state)
The operation is the same as the Projector button or the Remote Control
button “INPUT”.
Note1) When Network Unit is not installed, and Input-4 is selected, the
response will be “103”.
Note2) When Input is set to Monitor Out, and Input-1 is selected, the response
will be “101”.
Acceptable
“000” [CR]
Response
Unacceptable “%%%” [CR]