Expand Serial Command Specification
Page 14 of 46
Power Saving - Cooling Down
None
Power Saving State
C00: Power On
C01: Power Off
Note) during the above-mentioned state, when received other Commands, return the
error code that indicates the invalid Command.
8.4. Image Series Command
8.4.1. CF_BRIGHT Command
Command “CF_BRIGHT_%1” [CR]
%1
“000 ~ 063” -------------- Directly select the Brightness setting value
“UP” ---------------------- -- Brightness setting value +1
“DN” ---------------------- Brightness setting value -1
Details
Set the User control Brightness value.
The value set by their Command will not be saved to the Projector.
Therefore, when All Off the Projector, the value will return to the original
setting. (For stand-by mode, this value stays)
Only valid when it is in the usual Power On state.
Acceptable
“000” [CR]
Response
Unacceptable “Error Code” [CR]
8.4.2. CF_CONT Command
Command “CF_CONT_%1” [CR]
%1
“000 ~ 063” -------------- Directly select the Contrast setting value
“UP” ----------------------- Contrast setting value +1
“DN” ------------------------ Contrast setting value -1
Details
Set the User control Contrast value.
The value set by their Command will not be saved to the Projector.
Therefore, when All Off the Projector, the value will return to the original
setting. (For Stand-by mode, this value stays.)
Only valid when it is in the usual Power On state.
Acceptable
“000” [CR]
Response
Unacceptable “Error Code” [CR]
8.4.3. CF_COLOR Command
Command “CF_COLOR_%1” [CR]
%1
“000 ~ 063” -------------- Directly select the Color setting value
“UP” ----------------------- Color setting value +1
“DN” ------------------------ Color setting value -1
Details
Set the User control Color value.
The value set by their Command will not be saved to the Projector.
Therefore, when All Off the Projector, the value will return to the original
setting. (For Stand-by mode, this value stays.)
Only valid when it is in the usual Power On state.
Acceptable
“000” [CR]
Response
Unacceptable “Error Code” [CR]
