![background image](http://html1.mh-extra.com/html/canon/lv-7565/lv-7565_specification_4149439020.webp)
Expand Serial Command Specification
Page 19 of 46
8.5.3. CF_CLAMP Command
Command “CF_CLAMP_%1” [CR]
%1
“0000 ~ 0127” ----------- Directly set Clamp value
“UP” ----------------------- Clamp setting value +1
“DN” ----------------------- Clamp setting value -1
Details
Set Clamp. (Only valid when it is in the usual Power On state)
The value set by this Command will not be saved to the Projector. Therefore,
when All Off the Projector, the value will return to the original setting. (Stand
by mode stays)
Note: When %1 is directly specified, this command is not enough to execute for
the screen. To show up on the image, issue CF_SETPCADJ Command.
Acceptable
“000” [CR]
Response
Unacceptable “101” [CR] ---- When Input is Video series
8.5.4. CF_H-POS Command
Command “CF_H-POS_%1” [CR]
%1
“0000 ~ nnnn” --------- Directly set Horizontal Position
“nnnn” means maximum value. This result of current Total
Dots – Display Dots.
“UP” --------------------- Horizontal Position setting value +1
“DN” --------------------- Horizontal Position setting value -1
Details
Set Horizontal Position. (Only valid when it is in the usual Power On state)
The value set by this Command will not be saved to the Projector. Therefore,
when All Off the Projector, the value will return to the original setting. (Stand
by mode stays)
Note: When %1 is directly specified, this command is not enough to execute for
the screen. To show up on the image, issue CF_SETPCADJ Command.
Acceptable
“000” [CR]
Response
Unacceptable “101” [CR] ---- When Input is Video series
8.5.5. CF_V-POS Command
Command “CF_V-POS_%1” [CR]
%1
“0000 ~ nnnn” --------- Directly set Vertical Position
“nnnn” means maximum value. This result of current Total
Line – Display Line.
“UP” --------------------- Vertical Position setting value +1
“DN” --------------------- Vertical Position setting value -1
Details
Set Vertical Position. (Only valid when it is in the usual Power On state)
The value set by this Command will not be saved to the Projector. Therefore,
when All Off the Projector, the value will return to the original setting. (Stand
by mode stays)
Note: When %1 is directly specified, this command is not enough to execute for
the screen. To show up on the image, issue CF_SETPCADJ Command.
Acceptable
“000” [CR]
Response
Unacceptable “101” [CR] ---- When Input is Video series