Canon iR6570 series, Портативное руководство

Страница: 25 / 320

Chapter 1
1-11
- Make a thorough check of the block (front, rear) for melting by leakage, deformation by heat, cracking,
discoloration (yellowing). If a fault is found, replace the part with a new one immediately.
- Check the block (front, rear) including its inside.
- Do not use a cloth on which metal powder is found.
- If you have used solvent, make sure that the part has dried completely before mounting it back to the machine.
- Do not use a moist cloth unless specifically indicated.
- Be sure to provide scheduled servicing/replacement at the specified intervals.
F-1-1
Pickup/feeding roller
Registration roller
Transfer guide
Vertical path roller
Pre-exposure glass
Reversing roller
Duplex Feeding Roller
(right/left)
Dust-collecting roller
Disposing of toner.
Separation claw, fixing
Clean with solvent
and lint-free paper.
Fixing roller
Use cleaning oil and
lint-free paper.
Reflecting plate
Clean with a blower brush.
Primary/Transfer/Separation/
Dry wipe with lint-free paper;
then, clean with alcohol.
Dust-proofing glass
Dry wipe with lint-free paper.
Dry wipe with lint-free paper.
ADF reading glass
Copyboard glass
Clean it with a blower brush;
if dirt is excessive, dry wipe
with lint-free paper.
No. 1 through No. 3 mirrors
Scanning lamp
Feeding assembly
Clean with a moist cloth;
Developing assembly
base
Clean with a moist
Note 1: Do to leave traces of water.
assembly inlet guide
(upper/lower)
see Note 1.
Pre-transfer charging assembly
cloth; see Note 1.