Canon iR6570 series, Портативное руководство

Страница: 245 / 320

Chapter 5
5-95
<TEMPO>
T-5-57
AP-ACCNT Use it to set (CPCA) group ID for printing (job) from application
PrintMe built into the PS print server unit.
setting
0 to 9999999 (default: 0)
2
AP-CODE Use it to set the (CPCA) path for printing (job) from application
PrintMe built into the PS print server unit.
setting
0 to 99999999 (default: 0)
2
COPIER > OPTION > TEMPO
Sub-item Description Level
F-POT-SW Use it to enable/disable settings in the event of a transfer fault
caused by a fault in the potential sensor.
- Use it as a tentative remedy until the potential sensor is
replaced.
settling
0: off (default); 1: on
2
F-POT-D Use it to make settings in relation to transfer faults caused by a
fault in the potential sensor.
- The setting will be valid only when F-POT-SW is set to '1'.
- The degree of separation current may be 0>1>2.
setting
0: if user tends to use originals with low image ratio (text original
)
1: if user tends to use originals with high image ratio (photo
original)
2: do not use normally; however, use if double transfer occurs
(dropout at about 50 mm of leading edge)
2
F-HUM-SW Use it to enable/disable F-HUM-D settings in the event of a fault
in the environment sensor.
- Use it as a tentative remedy until the environment sensor is
replaced.
setting
0: off (default); 1: on (enable F-HUM-D setting)
2
COPIER > OPTION > INT-FACE
Sub-item Description Level