Canon IR5000 - iR B/W Laser, Руководство по обслуживанию

Страница: 181 / 252

CHAPTER 4 SERVICE MODE
4-77
BODY
Use it to make machine settings.
PO-CNT
Use it to turn on/off potential control.
Settings 0: off, 1: on (default)
PO-CNTMD
Use it to select a potential control mode.
Settings 0: one at time of power-up (default)
1: 10 mins and 60 mins after power-up (reduced mode)
2: 10 mins and 60 mins after power-up (normal mode)
W-CLN-P
Use it to set the intervals at which auto cleaning of the primary charging
wire is executed in terms of the number of prints.
Settings 100 to 2000 (default: 2000)
MODEL-SZ
Use it to switch default ratios display and ADF original size detection by
site.
Settings 0: AB (6R5E), 1: INCH (5R4E), 2: A (3R3E), 3: AB/INCH (6R5E)
FIX-TEMP
Use it to select down sequence mode.
Settings 0: OFF, 1: priority on fixing while controlling down sequence tempera-
ture to +10°C for all, 2: priority on productivity while controlling down
sequence temperature to -5°C for all
IDL-MODE
Use it to select idle rotation mode for the developing assembly.
Settings 0: OFF (no idle rotation; default)
1: auto control by environment sensor
2: idle rotation started when fixing temperature reaches 100°C
3: idle rotation started when main power switch is turned on
FSPD-S1
Use it to switch fixing control for special paper.
•
The selection of this mode disables the function of OHP-TEMP and
WARM-UP.
• The special paper mode (2 below) is valid for the 120/230-V model
only, and is executed when a source of paper assigned to thick paper is
selected.
Settings 0: normal mode (plain paper; default), 1: special paper 1 mode (in high
humidity environment, reduces fixing temperature),
2: special paper mode (thick paper)
COPIER>OPTION