Can-Am Roadster RT-622 2010, Руководство по обслуживанию, Страница: 17 / 52

Section 02 CHASSIS
Subsection 01 (WHEELS AND WHEELS HUBS)
10. Adjust the bearing gap.
10.1 Using a torque wrench, tighten hub nut
to 17 N•m (150 lbf• in ) to seat hub prop-
erly. Spin the hub at least 5 complete ro-
tations.
10.2 Loosen nut approximately 1/2 turn.
10.3 Finger tight the nut against the washer.
10.4 Further tighten nut just enough to see the
next groove aligned with a spindle hole.
10.5 Install a new cotter pin. Both ends of cot-
ter pin must be folded.
11. Install wheel. See
WHEEL INSTALLATION
.
Wheel Bearing Replacement
The bearing is not available in spare parts. When
bearing replacement is required, replace wheel
hub. See
WHEEL HUB REPLACEMENT
.
WHEEL HUBS
Wheel Hub Replacement
1. Remove the wheel. See
WHEEL REMOVAL
.
2. Remove the protective cap.
3. Remove and discard the cotter pin.
4. Remove the wheel hub nut and its washer.
rmo2010-005-030_a
1. Protective cap
2. Cotter pin
3. Wheel hub nut
4. Washer
5. Remove the wheel hub from the spindle and
discard it.
6. Grease the bearings of the new hub with
hi-temp bearing grease NLGI-2 or an equiva-
lent.
NOTICE
Do not fill up more than 20% of the
cavity between the bearings, approximately
30 ml (1 U.S. oz). Fill cap with approximately
60 ml (2 U.S. oz).
7. Place hub on the spindle and secure it loosely
using the hub nut and its washer.
8. Adjust the bearing gap.
8.1 Using a torque wrench, tighten hub nut to
17 N•m (150 lbf• in ) to seat hub properly.
Spin the hub at least 5 complete rotations.
8.2 Loosen nut approximately 1/2 turn.
8.3 Finger tight the nut against the washer.
8.4 Further tighten nut just enough to see the
next groove aligned with a spindle hole.
8.5 Install a new cotter pin. Both ends of cot-
ter pin must be folded.
TIRES
Tire Pressure
Check tires pressure. Tire pressure must be
checked while the tire is cold.
NOTE: Do not check the tire pressure immedi-
ately after towing the trailer. Allow at least three
hours for a tire to cool, if the trailer has been
towed for as much as 1.6 km (1 mi).
TIRE PRESSURE
Cold tire 241 kPa (35 PSI)
Tire Inspection
Replace the tire if the tire tread has less than
1.6 mm (1/16 in) depth or if the built-in wear indi-
cator bars are visible and flush with the remainder
of the tire tread.
Inspect both sidewalls of each tire for any bubble,
cut or bulge; and replace a damaged tire before
towing the trailer.
WARNING
A bubble, cut or bulge in the sidewall can re-
sult in a tire blowout and loss of control which
can lead to serious injury or death.
Tire Replacement
This trailer is equipped with specific type tires.
NOTICE
Use tire changer equipped for mag
wheels to avoid damage to the wheels.
WARNING
Use the same type and brand of tire for both
wheels. Use only tires in accordance with
specifications for this trailer.
rmr2010-064
7