Can-Am 2008 Outlander 400 EFI, Руководство по ремонту, Страница: 500 / 599

ADJUSTMENTS
WARNING
Low pressure may cause tire to deflate and
rotate on wheel. Overpressure may burst the
tire. Always follow recommended pressure.
Since tires are low-pressure type, a manual
pump should be used.
NOTE:
Tire pressure varies with temperature and
altitude.
NOTE:
A pressure gauge is supplied in the tool kit.
1. Inflate tires to the specified air pressure. Refer
to the following table.
RECOMMENDED AIR PRESSURE
FRONT REAR
Maximum
34.5 kPa (5 PSI) 34.5 kPa (5 PSI)
Outlander
400 Series
Minimum
31 kPa (4.5 PSI) 31 kPa (4.5 PSI)
Maximum
34.5 kPa (5 PSI) 34.5 kPa (5 PSI)
Outlander
MAX 400
Series
Minimum
31 kPa (4.5 PSI) 31 kPa (4.5 PSI)
Maximum
34.5 kPa (5 PSI) 34.5 kPa (5 PSI)
Outlander
500 Series
Minimum
31 kPa (4.5 PSI) 31 kPa (4.5 PSI)
Maximum
34.5 kPa (5 PSI) 34.5 kPa (5 PSI)
Outlander
MAX 500
Series
Minimum
31 kPa (4.5 PSI) 31 kPa (4.5 PSI)
Maximum
48.3 kPa (7 PSI) 48.3 kPa (7 PSI)
Outlander
650 / 800R
Series
Minimum
31 kPa (4.5 PSI) 31 kPa (4.5 PSI)
Maximum
48.3 kPa (7 PSI) 48.3 kPa (7 PSI)
Outlander
MAX 650 /
800R Series
Minimum
31 kPa (4.5 PSI) 34.5 kPa (5 PSI)
Maximum
48.3 kPa (7 PSI) 48.3 kPa (7 PSI)
Renegade
Series
Minimum
34.5 kPa (5 PSI) 37.9 kPa (5.5 PSI)
Brake Disk Cleanup
1. Clean front and rear brake discs using pulley
flange cleaner (P/N 413 711 809).
NOTICE
A thin layer of anticorrosion product
can be present on the brake disc and must be
removed before using the vehicle. Not con-
forming to this procedure may lead to a brake
chattering and the brake pads replacement
would be necessary to solve the problem.
Protective Materials
1. Ensure that all protective materials are re-
moved from vehicle.
ADJUSTMENTS
General Guidelines
All adjustments have already been performed
at factory, it is only necessary to validate them.
However, if readjustment is needed, refer to the
appropriate
ATV SHOP MANUAL for the proper
procedure.
Transmission Lever
1. Verify that transmission lever works properly
and adjust if required.
vmo2006-007-007
TYPICAL - TRANSMISSION LEVER
Suspension
WARNING
Left and right adjusting cams must always
be set at the same position. Never adjust
one adjusting cam only. Uneven adjustment
can cause poor handling and loss of stability,
which could lead to an accident.
NOTE:
The front suspension of Outlander 400 se-
ries and Outlander 500 series are not adjustable.
Front and Rear Suspension
1. Adjust the spring preload as per the owner’s
preference.
2. Refer to the following table for proper adjust-
ment.
18 / 34 2009-2 PREDELIVERY
sales@midwestmanuals.com
sales@midwestmanuals.com