Can-Am 2008 Outlander 400 EFI, Руководство по ремонту, Страница: 472 / 599

September 24, 2008 Subject: Throttle Plate Opening (All Models Except
CE) No.
2009-8
YEAR MODEL MODEL NUMBER SERIAL NUMBER
2009
Outlander™ and Renegade™
All All
To ensure optimum engine performance on vehi-
cles produced before October 2008, at PDI, the
throttle plate opening should be checked using
B.U.D.S.
THROTTLE PLATE
OPENING VERIFICATION
1. Using B.U.D.S. software, select the Setting
tab. The display shows the actual throttle open-
ing in degrees.
vmr2006-014-084_b
1. Throttle opening display
NOTE:
Do not click on the Reset button.
2. Fully depress throttle lever (wide open position)
and hold. Read throttle opening.
THROTTLE OPENING
82° to 86°
If opening is out of specification, perform the
THROTTLE LEVER STOPPER SCREW SETTING
.
THROTTLE LEVER
STOPPER SCREW
SETTING
1. Loosen the stopper screw lock nut.
2. Fully depress throttle lever (wide open position)
and hold.
3. Loosen stopper screw until it just releases throt-
tle lever.
vmr2006-014-068_a
1. Lock nut
2. Stopper screw
4. Turn stopper screw clockwise until it contacts
throttle lever again.
5. From this point, tighten stopper screw 1/2 turn
(to remove strain on the cable).
6. Keep the stopper screw from turning and tight-
en lock nut.
7. Read throttle opening. If throttle opening is out
of specification, perform adjustment again.
NOTE:
If the proper adjustment is impossible to
reach with this procedure, perform a throttle cable
adjustment, refer to the appropriate Shop Manual.
Printed in Canada. (vbs2009-011 en AG)
©2008 Bombardier Recreational Products Inc. and BRP US Inc. All rights reserved. 1 / 1
®™ and the BRP logo are trademarks of Bombardier Recreational Products Inc. or its affiliates.
sales@midwestmanuals.com
sales@midwestmanuals.com