Made in Germany
Camtec Power Supplies GmbH - Gewerbestraße 30 - DE-76327 Pfinztal / Germany
S.20/20 (07/2017.01.0)
Tel. +49 (721) 46596 - 0 Fax +49 (721) 46596 - 77
www.camtec-gmbh.com
-
(Technical changes and errors reserved. This product may not be used in life support systems.)
Ordering Codes
Term
Information
Camtec Article Number
CPS-EX2000.024
24Vdc
3041110002CA
CPS-EX2000.036
36Vdc
3041110003CA
CPS-EX2000.048
48Vdc
3041110004CA
CPS-EX2000.072
72Vdc
3041110005CA
CPS-EX2000.110
110Vdc
3041110006CA
TCP/IP Interface
Including i.Drive Software Download
In preparation
19“ Frontplate 2U
Including mounting material
2201006001CA
19“ Frontplate 3U
Including mounting material
2201007001CA
19“ Blindplate 2U
Including mounting material
2201009001CA
19“ Blindplate 3U
Including mounting material
2201010001CA
19“ Subrack 2U 84TE
3 Modules mountable only in conjunction with front panel 2U orderable
2201004001CA
19“ Subrack 3U 84TE
5 Modules mountable only in conjunction with front panel 3U orderable
2201005001CA
19“ Rack-Rail
2x Support Rails for rack mount, mounting kit included
2201008001CA
Cable Management Rail
Cable support for rack mount, mounting kit included
In preparation
Hard Mount Holder strait
2x Holder for strait wall mount, mounting kit included
2201011001CA
Hard Mount Holder flat
2x Holder for flat wall mount, mounting kit included
2201012001CA
Cooling System Flange
Front/Rear Flange for cooling system, mounting kit included, only for wall
mounting!
In preparation
Safety regulations: Please read these instructions completely before using the equipment. Keep these
instructions on to hand. The device may only be operated by trained specialist staff.
Installation:
1) The device is designed for devices and systems
that meet the standard requirements for hazardous
voltages, power and fire prevention.
2.) Installation and service only by trained persons.
The AC power must be switched off. The work is to be
labeled; accidental reconnection of the system must
be prevented.
3.) Opening the device, its modification, loosening
bolts or operation outside the specified herein
specification or in an unsuitable environment, has the
immediate loss of warranty to follow. We disclaim any
responsibility for any resulting damage to persons or
things.
4.) Note: The device must not be operated without an
upstream circuit breaker (CB). We recommend the use
of B-Type 16A. It is prohibited to use the unit without
PE. It may be necessary upstream device has a power
switch.
Warning
:
Non-compliance can result in fire and serious
injury or death.
1. Operate the appliance without PE connection.
2. Before connecting the device to the AC
network, make wires free of voltage and assure
accidently switch on.
3.
Allow neat and professional cabling
.
4. Never open nor try to repair the unit. Inside
are dangerous voltages that can acause
electrical shock hazard.
5.
Avoid metal pieces or other cunductive
material to fall into the item
6. Do not operate the device in damp or wet
conditions
7. Do not operate the unit under EX-conditions
All parameters after 15 minutes of continuous operation at full load / 25°C / 230Vac 50/60Hz, unless otherwise indicated.
