CAMSO 30/36D23MC, Руководство по эксплуатации и обслуживанию

Страница: 30 / 48

CBP-436(2017) Operation and Maintenance Manual-CTS Tractors Camso | 12-17 | 30
WARNING
Lubricants should not to be poured in the environment. Collect them in
suitable containers and deliver to the licensed companies for waste disposal
in accordance with the present law in force.
Avoid any contact of the lubricant with the rubber parts. If oil is spilled onto
the track, clean oil from track surface with dry towel. Do not use cleaning
solvents or diesel fuel to clean oil from track surface as track damage may
occur.
6.3 Track alignment adjustment
This Camso track system is designed without a track alignment adjustment. Tracks will tend to
self-align themselves and there is no need to adjust the alignment of the track.
6.4 Track system inspection
Track System
Inspect track system for material build-up on frames, drive sprocket and wheels. Clean material
from undercarriage.
Oscillation Limiting Brackets and Hardware
Inspect the oscillation limiting brackets and hardware for worn, broken or loose parts. Also
inspect oscillation brackets for mud and material build up that will limit travel of the track system.
Clean material from oscillation brackets to allow full movement of the undercarriages.
Drive Sprocket
Inspect drive sprocket for worn surfaces and sharp edges. If sprocket becomes worn, replace
the drive sprocket. Watch for material build up on the face of the drive sprocket. Clean any
material build up on the face of the sprocket to prevent damage to the inner track surface. Also
watch for mud, debris or ice packing in the drive sprocket. If too much material builds up in the
sprocket or on the sprocket face, track engagement may be affected and damage to the track
may occur.
Drive Sprocket Scrapers
Drive sprocket scrapers prevent excessive build up of material on the surface of the drive
sprocket. Material build up on the drive sprockets results in damage to the inside surface of the
tracks. If material build up is identified, adjust scrapers so that there is no more than 3 mm gap
between the scrapers and the drive sprocket or if needed, install new drive sprocket scrapers.
Drive sprocket scrapers are available from Camso.