www.camplux.com
1
41
Visit Us: Camplux.com
3330-A Marathon Ct Charleston, SC 29418
(844) 538-7475
Error code guide
When an error code is displayed :
1. Close the hot water faucet, turn off the switch on the remote control.
2. Wait for about 5 minutes before turning the switch on again.
3. Open the hot water faucet.
If error code remains down:
1. Close the hot water faucet and turn off the switch on the remote control.
2. Take the proper action shown below and attempt operation of the appliance
again.
If the error code still shown:
1. Turn off the hot water faucet and turn off the switch on the remote control.
2. Take care of the error code displayed and contact customer service at
(844)538-7475 or email to [email protected] for any assistance.
CAUTION:
For your safety DO NOT attempt repair of gas piping, remote
control, burners, vent connectors or other safety devices. Refer repairs to
qualified service personnel.
CAUTION:
Make certain power to water heater is “OFF” before removing
protective cover FOR ANY REASON.
CAUTION:
Label all wires prior to disconnection when servicing controls.
Wiring errors can cause improper and dangerous operation. VERIFY PROPER
OPERATION AFTER SERVICING.
Error Code
Error Description
E0
Hot water sensor failure
Ignition system failure
The gas valve is not opened or fully
opened. Water shut off valve is not
open. Junction port loose.
Junction pot loose,short circuit.
E2
Flame failure protection
Over-heating protection
Pressure switch
Failure to detect the flame.
Dry Combustion.Problem of over
heating controller.
Motor Problem,voltage of power supply
is too low.
E1
E3
E5
Solenoid valve
Open circuit of the valve ,short circuit
of the valve,none of the above.
E7
E8
Possible Cause
How To Do
Residual fire issue
Solenoid or PCB controller malfunction.
Check and open gas fully.
Check and open water valve.
Call for service.
Call for service.
Check if gas off /empty tank.
Check if the flame sensor
damaged.
Call for service.
Call for service.
Connect the valve,replace the
valve,replace the PCB board.
Call for service.