6.1 Mounting equipment inside the
enclosure
When mounting a data logger and other components inside an enclosure, care must be taken to
seal the enclosure openings to prevent moisture and insects from getting into the inside of the
enclosure. There are two main methods of passing system cabling into and out of the enclosure:
1.5-inch conduits and individual compression fittings for each cable.
6.1.1 Enclosures with one or two 1.5-inch conduits
1. If installing the optional Door-Open Indicator Kit, follow the procedure described in
2. If installing the 5-inch or 9-inch DIN-Rail Mounting Kit, follow the procedure described in
(p. 31). These kits facilitate wiring when many wires need to be
connected to one terminal.
3. If installing an enclosure stack mounting kit, follow the procedure described in
(p. 37). A stack mounting kit allows components to be raised 3 inches above the
backplate, allowing one component to be stacked above another to save space. Raising a
component from the backplate is also done to improve access to a component that may be
partially blocked by other, taller equipment mounted in the enclosure.
Enclosures
7
Содержание ENC 10/12
Страница 1: ...Revision 02 2020 Copyright 2006 2020 Campbell Scientific Inc ...
Страница 24: ...FIGURE 6 12 Tripod leg base LM mounting brackets FIGURE 6 13 Enclosure mount receiver Enclosures 18 ...
Страница 47: ...FIGURE C 5 Exploded view of a CR1000X and AM16 32B mounted on a Stack Mounting Kit Enclosures 41 ...