1. Introduction
Environmental enclosures protect data loggers and peripherals from water and most pollutants.
Campbell Scientific standard enclosures include the ENC10/12, ENC10/12R, ENC12/14, ENC14/16,
and ENC16/18. For cable entry, Campbell Scientific offers a choice of one 1.5-inch diameter
conduit, two horizontally-arranged 1.5-inch diameter conduits, two vertically-arranged 1.5-inch
conduits (ENC16/18 only), or individual compression fittings. Multiple cables can use the
conduit(s) whereas each compression fitting only allows a single cable to enter the enclosure.
The individual compression fittings provide a more water-tight seal.
Besides standard enclosures, Campbell Scientific offers prewired enclosures that combine
flexibility with ease of use. Prewired enclosures include the PWENC12/14, PWENC14/16, and
PWENC16/18. Customers have the flexibility to choose their system components, but installation
is easy because sensors are simply attached to prewired connectors on the outside of the
enclosure.
Prewired enclosures are shipped with the same enclosure supply kit (
and use the same brackets for mounting to a tripod or a tower (
(p. 12)). The maintenance information (
(p. 24) and
(p. 24)) is also applicable to prewired enclosures.
Campbell Scientific also offers a variety of factory installed bulkhead antenna cables. These
cables provide a connector for an antenna on the outside of the enclosure used by a modem,
radio, or a satellite transmitter.
Campbell Scientific enclosures are manufactured with non-corrosive polyester and reinforced
with fiberglass. These white UV-stabilized enclosures reflect solar radiation, reducing
temperature gradients inside the enclosure without requiring a separate radiation shield. A door
gasket, external ground lug, stainless steel hinge, and lockable hasp are included. Campbell
Scientific enclosures were rated NEMA 6P before being modified to include conduit(s) or
compression fittings.
Data loggers, peripherals, and brackets are mounted to an internal plate punched with a grid of
half-inch-on-center holes.
An internal backplate is included with each ENC10/12, ENC10/12R, ENC12/14, and ENC14/16
enclosure. Two internal mounting plate options are offered for the ENC16/18. The –SB option
provides a backplate similar to the one included with the other enclosures. The –EL and –ER
options provide both a backplate and a sideplate.
Enclosures
1
Содержание ENC 10/12
Страница 1: ...Revision 02 2020 Copyright 2006 2020 Campbell Scientific Inc ...
Страница 24: ...FIGURE 6 12 Tripod leg base LM mounting brackets FIGURE 6 13 Enclosure mount receiver Enclosures 18 ...
Страница 47: ...FIGURE C 5 Exploded view of a CR1000X and AM16 32B mounted on a Stack Mounting Kit Enclosures 41 ...