NOTE:
Refer to
(p. 12) for steps 7–9.
7. Place two of the desiccant packs from the Enclosure Supply Kit inside of the enclosure.
Reseal the other two inside the plastic bag to use later (see
24)).
8. Remove the backing from the humidity indicator card and attach the card to the right side
of the enclosure.
9. Rotate each compression fitting so that the fitting clamps tightly against the sensor cable
to provide a water-tight seal (see
(p. 11)).
FIGURE 6-5. This ENC16/18 enclosure with the “–ES” option houses the equipment
commonly used in a GOES satellite system
6.2 Attaching an enclosure to a tripod mast
The “–MM” mount option is intended for mounting an enclosure to the mast of a tripod. An
enclosure ordered with this option will be shipped with a three-piece bracket mounted to the top
Enclosures
12
Содержание ENC 10/12
Страница 1: ...Revision 02 2020 Copyright 2006 2020 Campbell Scientific Inc ...
Страница 24: ...FIGURE 6 12 Tripod leg base LM mounting brackets FIGURE 6 13 Enclosure mount receiver Enclosures 18 ...
Страница 47: ...FIGURE C 5 Exploded view of a CR1000X and AM16 32B mounted on a Stack Mounting Kit Enclosures 41 ...