! IMPORTANT !
This pressure washer is equipped with a microswitch
sensitive to water flow. This Instant Start/Stop switch
(ISS) senses water flow in the pump. When the trigger is
released, water stops flowing through the pump. The ISS
then automatically turns the motor off to protect pump
from overheating.
OPERATION
1. Pull trigger on gun.
2. Turn the “ON/OFF” switch to “ON”.
3. Release trigger. The pressure washer motor will stop
running.
4. To spray again, pull trigger and motor and pump will
restart.
NOTE:
Occasionally the motor may run for a short time
to bring fresh, cool water into the pump even if trigger
is released. This is part of normal operation and will not
damage the unit.
Always turn the “ON / OFF” switch to
“OFF” then trigger gun to release hose
pressure before unplugging power cord.
Risk of equipment damage. Always
make sure the “ON / OFF” switch on the
unit is “OFF” and unit is unplugged prior to storage.
Risk of Injection. Unit will
start spraying when trigger
is squeezed if “ON / OFF” switch is in “ON”
position.
Call 1-800-330-0712
for Technical Service
2
Operating Instructions and Parts Manual
www.chpower.com
Important Safety Instructions
When using this product, basic precautions should always be
followed, including the following:
1. Read all instructions before using the product.
2. ALWAYS disconnect power before disassembling or
repairing the unit.
3. Follow all safety codes as well as the Occupational Safety
and Health Act (OSHA).
4. Ensure safety devices are operating properly before each
use. DO NOT remove or modify any part of the gun or
unit.
5. Know how to stop this product and bleed pressure
quickly. Be thoroughly familiar with the controls.
6. Stay alert – watch what you are doing.
7. Do not operate the product when fatigued or under the
influence of alcohol or drugs.
8. Keep operation area clear of all persons.
9. Do not overreach or stand on unstable support. Keep
good footing and balance at all times.
10. Follow the maintenance instructions specified in the
manual.
11. This product is provided with a ground fault circuit
interrupter, GFCI, be sure to inspect cord and GFCI prior
to use. Any repair or replacement of the power cord
must be performed by a qualified (licensed or certified)
electrical technician.
12. Never use an extension cord with this product.
13. The power cord on this product contains chemicals,
including lead, known to the State of California to cause
[cancer and] birth defects or other reproductive harm.
Wash hands after handling.
14. To reduce the risk of injury, close supervision is necessary
when a product is used near children.
Risk of electrocution
• Inspect cord before using - Do not use if cord
is damaged.
• Keep all electrical connections dry and off the ground.
• Do not touch plug with wet hands.
• This product is provided with a ground fault circuit
interrupter built into the power cord plug. If
replacement of the plug or cord is needed, use only
identical replacement parts.
• Do not spray electrical apparatus and wiring.
