CAME 801MB-0080, Руководство по установке

Страница: 35 / 128

p.
3
- M
an
u
al
FA
0
0
9
9
5
-E
N
- 0
1/
2
0
18 - © C
A
M
E S
.p.
A
. -
Tr
ansla
tio
n of t
he o
riginal inst
ru
ct
io
ns
GENERAL PRECAUTIONS FOR INSTALLERS
⚠
CAUTION! Important safety instructions.
Follow all of these instructions. Improper installation can cause serious bodily
harm.
Before continuing, also read the general precautions for users.
This product must only be used for its specifi cally intended purpose. Any other use is
dangerous. Came S.P.A. is not liable for any damage caused by improper, wrongful and
unreasonable use. • This manual's product is defi ned by machinery directive 2006/42/CE as
"partly-completed machinery". Partly-completed machinery is a set that almost constitutes
a machine, but which, alone, cannot ensure a clearly defi ned application. Partly-completed
machinery is only destined to be incorporated or assembled to other machinery or other
partly-completed machinery or apparatuses to build machinery that is regulated by Directive
2006/42/CE. The fi nal installation must be compliant with European directive 2006/42/CE
and current European reference standards • Given these considerations, all procedures stated
in this manual must be exclusively performed by expert, qualifi ed staff . • Laying the cables,
installation and testing must follow state-of-the-art procedures as dictated by regulations
Before installing the operator, check that the gate is in proper mechanical condition, that it is
properly balanced and that it properly closes: if any of these conditions are not met, do not
continue before having met all safety requirements. • The operator cannot be used with gates
fi tted with pedestrian doors, unless its operation can be activated only when the pedestrian
door is in safety position. • Make sure that people cannot bet entrapped between the gate's
moving and fi xed parts due to the gate's movement. • Do not fi t the operator upside down or
onto elements that could yield to its weight. If necessary, add reinforcements to the fastening
points • check that the temperature range appearing on the operator is suited to the place
of installation • Do not install door or gate leaves on tilted surfaces • check that no lawn
watering devices spray the operator with water from the bottom up • Suitably section off and
demarcate the entire installation site to prevent unauthorized persons from entering the area,
especially minors and children. • Use proper protections to prevent mechanical hazards when
people are loitering around the machinery's range of action, for example avoid fi nger crushing
hazards between the drive arm and the mechanical stops when the door is opening, and so
on). • Any residual risks must be indicated clearly with proper signage affi xed in visible areas.
All of which must be explained to end users • Affi x cautionary signs, such as the door plate,
the gate plate, wherever needed and in plain sight. • All opening controls must be installed at
least 1.85 m from the perimeter of the gate's working area, or where they cannot be reached
from outside the gate. • If the operator is installed lower than 2.5 from the ground or from any
other access level, fi t any protections and signs to prevent hazardous situations. • Make sure
that mechanical stops are already installed • Make sure the operator is installed onto a sturdy
surface that is protected from any collisions • Unless the key-operation is functioning (for
e.g. keypad selector, key-switch selector, transponder selector, and so on), any maintained-
action control devices must be installed at least 1.5 m from the ground and out of reach
from unauthorized users. • The manufacturer declines any liability for using non-original
products; which would result in warranty loss • All switches in maintained action mode must
be positioned so that the moving gates leaves, the transit areas and vehicle thru-