Calrec Artemis, Инструкция по установке и техническое руководство

Страница: 14 / 124

14 ARTEMIS
Digital Broadcast Production Console
Control Surface
Accesstosurfaceconnections
The data connections from the Artemis
processing core to the control surface
are made through a small cut-out on the
rear cover of the control surface located
near the IEC AC input connectors. Two
fibres or Cat5e cables need to be routed
through the cut-out to connect to the
Surface Switches inside the control
surface. A rear interface panel provides
power connections on three IEC's along
with a connection point for earthing the
chassis. Audio and data connections
are also provided for interfacing to audio
driven devices along with ancillary data
connections.
The format of the interface plate may vary
depending on the optional hardware fitted
within the surface. Connector and pin-out
information is provided in the Console
Connection section of this document.
Accesstointernalsurface
components
Removing up-stand meter panels and
control surface panels gives open access
to the Surface Switches and other internal
components. Some early production
models are fitted with hinged rear covers
that allow access from the back of the
control surface.
Non-hinged rear covers can be removed,
however, care needs to be taken to
support the weight of internal components
mounted on the inside of the rear covers
and the cabling to them..
FIGURE 1 - REAR OF ARTEMIS CONTROL SURFACE
REAR CONNECTOR INTERFACE AND COVERS
Anciliary Inputs
PC interface (RJ45)
Talkback Microphone
Output (XLR Male)
Primary Surface to
Processing Rack
Connection (SFP)
Secondary Surface to
Processing Rack
Connection (SFP)
Screen/Anciliary
power
Surface Power Headphone
Input (D25
Meter IN/OUT
connectors (x8)
Spare
Spare