Calix GigaSpire BLAST u12 GS202xE, Руководство по установке

Страница: 33 / 41

33 Install Guide
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
.
Additional Comments

Once your GigaSpires LED turns BLUE, you are connected to the upstream WAN
modem.

At start-up, GigaSpire Wi-Fi radios are defaulted to on.

To configure your GigaSpire, connect an Ethernet cable between your PC and the LAN
port of your GigaSpire and enter the default IP Address of the device (192.168.1.1) into
your browser.

Wi-Fi radios can be configured using the default settings:

SSID: Printed on the product label in the gift box. (CXNKxxxxxxxx)
 Number of radios: 2 (2.4 GHz and 5 GHz)

Wi-Fi Protocol supported: 802.11a/b/n/g/ac/ax

Credentials: Login and password printed on the product label in the gift box.
LED States - GigaSpire Turn-up
The LED's located on the corner of the GigaSpire provide information on the status and
current state of the device. Below, you will find a detailed status of the power-up cycle.
Unit Status
Power-up
Status
Function LED Status
Off
Power is off.

The unit has not been turned on or

There is no power to the unit or

The UPS battery has been
discharged and there is insufficient
power to continue operation.
Note: All four LEDs are off
Note: Applies to GS2026E and
GM1020
Booting Up,
Software Upgrade in
Process
Unit is in the boot-up process or
service/software is being upgraded.
Flashes cyan every second assuming
software has taken over.
Note: All four LEDs On.
Boot-up Failure
Book-up failed (assuming software has
taken over)
Note: Cycles at 8/10 of a second
Note: All four LEDs on.