Calix GigaSpire BLAST u12 GS202xE, Руководство по установке

Страница: 28 / 41

Proprietary Information: Not for use or disclosure except by written agreement with Calix.
.
Chapter 3
Final Set-up and Testing
BLAST Reset Behavior
The reset button will do a "restore to defaults" when held for 10 seconds which clears
everything except what was set by Smart Activate (restores defaults to whatever was set up
during installation by the service provider).
Calix EDGE systems support a variety of system reset functions and provide multiple
methods for invoking each of these functions, as described in this topic. Calix defines these
functions and behaviors as follows:
1.
Basic reset (reboot): Restarts the router.
2.
Configuration reset: Resets the RG configuration settings (those visible to the
subscriber/Admin user in the EWI, such as SSIDs, LAN IP scope, etc.) to defaults, but
retains operator-configured management settings (those visible only to the Support user
in the EWI, such as ACS URL and SPID).
3.
Factory reset: Resets the router (and any attached mesh satellites) to factory default
settings. A factory reset also removes devices from network management systems,
including Calix Support Cloud and the Smart Home Admin Dashboard, where
applicable.
These reset functions can be used as troubleshooting and/or operations tools for
reset/removal scenarios, whether the device is deployed as an RG or as a subtended WAP or
Satellite (GigaSpire BLAST or GigaMesh). Hardware-invoked resets behave differently
depending on how long the reset button is pressed, as described below.
Note: Performing a reset does not remove the default SPID and ACS URL that has been
assigned to the system. This is designed intentionally, so that u6 systems cannot be taken out
of service by the subscriber if they were to cancel and/or move to another service provider.
The SPID and ACS URL are unique for each service provider.