Calix GigaSpire BLAST u12 GS202xE, Руководство по установке

Страница: 39 / 41

39 Install Guide
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
.
WPS Status
Power-up
Status
Function LED Appearance LED Status
1.
GigaSpire
booting up
Unit is in the process of booting up or
service/software is currently being
upgraded.
Note: If the GigaMesh is connected via
WIRED backhaul, ignore pairing and
signal strength behavior and proceed to
step x below.
Alternating on/off at 1000 m/sec per
cycle
2.
Boot-up Failure
GM1020 boot-up failed (assume failure
occurs after software has taken control
of the LEDs)
Alternating on/off at 800 m/sec per
cycle
3.
WPS Pressed,
Pairing Attempt
Started
WPS is enabled upon pressing the
WPS a single time. The GS202xE will
stay in pairing mode for 120 seconds.
During this time, other Wi-Fi capable
devices can be paired to the GS202xE
Gateway Wi-Fi radios (5.0 GHz band)
by initializing a similar WPS function on
the other GS202xE or GM1020 mesh
satellite thereby creating an association
with the Gateway SSID and the mesh
satellite. When the Gateway and the
mesh satellite are successfully paired,
they will have the same primary SSID
(2.4 and 5.0 GHz).
WPS LED behavior takes priority even
if Alexa is used during the pairing
period.
LED bar begins flashing at 500 m/sec
intervals and continues for 120
seconds.
4.
Display Signal
Strength
(Positioning)
Displays signal strength after any one
of the following conditions are met (after
IP address has been obtained):

Successful pairing completed

Re-start completed (and previous
pairing with gateway has been
restored)

Re-association of the link with the
gateway after lost link (gateway
was powered down the restored)
If pairing succeeds:

If the GigaMesh is too close to the
gateway but still connected, top
LED will light steady green.

If the GigaMesh is too far from the
gateway, bottom LED will light
steady green.

When at the ideal location, the
entire light bar (all 4 LEDS light
steady green)

Note: After 60 seconds, the light
bar begins to reflect gateway status
(not shown)