Manufactured in the U.S.A.
alum
LEDs
™
CALIFORNIA ACCENT LIGHTING, INC.
2820 E. Gretta Lane, Anaheim, CA 92806
ph. 800.921.CALI (2254) | fx. 714.535.7902 | [email protected] | calilighting.com
© CALI. All rights reserved. CALI reserves the right to make changes or withdraw specifications without prior notice.
Page 5 of 11
INSTALLATION
ALS
600T-AD
2019.12.5 Rev 2
ALS600T-AD-AA-BM-X
4.
Snap fixture into mounting bracket and install set screws on both sides. Ensure fixture is
secured in place, and spacing is accurate according to the spacing diagram.
Set Screw
5.
Loosen set screw until the mounting bracket can move freely. Turn the mounting bracket
until desired angle is achieved, then mate the locking bump with locking hole. Tighten set
screw until mounting bracket is secured in place.
2.
Determine number of mounting arms needed. Use a minimum of two mounting arms per
fixture. Mount arms 6” from center of mounting plate to end of fixture.
Refer to spacing diagrams for details.
3.
Mark location where mounting arms will be installed. Screw arms to desired surface using
proper drill bit for surface and screw size.
ASSEMBLED END VIEW
Add 0.93” to overall height for fixtures with louver installed
2.00”
4.61”
X” (Specify Length)
Mounting Bracket
Locking Hole
Set Screw
Locking Bump
Angle Increments
-30°
-15°
0°
15°
30°
45°
60°
75° 90°
210°
195°
180°
165°
150°
135°
120°
105°
6.
If applicable, connect disconnects between fixtures. Push and twist cap to lock connector.
Note:
Shrink tube required for wet location installations.
Shrink Tube
Apply Heat
1.
Measure area where luminaire will be installed. Use a chalk line to ensure a straight installation.
SPACING DIAGRAMS
4’
3’8”
2’8”
6”
6”
Mounting Arms
Example:
4’ Fixture
4’
3’8”
2’8”
6”
6”
Mounting Arms
4’
3’8”
2’8”
6”
6”
Mounting Arms
8’
Example:
8’ Fixture (4’ + 4’)
3’
2’8”
1’8”
6”
6”
4’
3’8”
2’8”
6”
6”
Mounting Arms
4’
3’8”
2’8”
6”
6”
Mounting Arms
11’
Example:
11’ Fixture (4’ + 4’ + 3’)
