Manufactured in the U.S.A.
alum
LEDs
™
CALIFORNIA ACCENT LIGHTING, INC.
2820 E. Gretta Lane, Anaheim, CA 92806
ph. 800.921.CALI (2254) | fx. 714.535.7902 | [email protected] | calilighting.com
© CALI. All rights reserved. CALI reserves the right to make changes or withdraw specifications without prior notice.
Page 4 of 11
INSTALLATION
ALS
600T-AD
2019.12.5 Rev 2
Mounting Clips
Set Screw
4’
Mounting Clip
2”
2”
2’
2”
2”
3’
2”
2”
2”
2”
1’
4.
Lay mounting clips and pre-drill using proper drill bit for surface and screw size.
Recommendation:
8/32 x 1” screw.
Note:
Allow 0.25” clearance for lateral expansion of assembled mounting clips.
Only install mounting clips on flat, even surfaces.
2.
Mark location where mounting clips will be installed along chalk line.
3.
Use 2 mounting clips for each fixture.
5.
Screw mounting clips to surface, then snap fixture into mounting clips. Install set
screws if needed. Set screws are required for downward and outward facing applications.
ASSEMBLED END VIEWS
2.55”
2.89”
Without Louver (Closed)
3.56”
4.12”
Without Louver (Open)
2.65”
3.82”
With Louver (Closed)
4.49”
4.22”
With Louver (Open)
1.
Measure area where luminaire will be installed. Use a chalk line to ensure a straight installation.
