CalderaSpas Olympia, Руководство пользователя

Страница: 12 / 28

9
SPA-SIDE CONTROL OPERATION
Your spa-side control panel consists of an LED display and convenient touch
pads that allow you to set the water temperature and adjust the skim/filter
cycle settings, as well as control the hydrotherapy jets, and light from
spa-side.
LED DISPLAY
The LED display on your spa-side control panel continually shows the spa’s
actual water temperature. In certain situations, it will also display other
messages. See TROUBLESHOOTING section.
TEMPERATURE CONTROL
The set temperature range is from 50°F to 104°F. The factory-set temperature
is 102°F. Whenever power is disconnected and then reconnected to the spa,
the water temperature will automatically seek this temperature, unless you set
it otherwise using the temperature controls.
Pressing the Temp Plus (+) button displays the spa’s set temperature. To
increase the set temperature, press the Temp Plus (+) button again, once for
each degree of increased temperature desired. If you hold the button down,
the set temperature will increase by one degree every half second.
Pressing the Temp Minus (-) button displays the spa’s set temperature. To
decrease the set temperature, press the Temp Minus (-) button again, once for
each degree of decreased temperature desired. If you hold the button down,
the set temperature will decrease by one degree every half second.
JET PUMP CONTROL
Pressing the Jet button changes the jet pump functions, depending on the number of presses:
Oympia Spa only:
1st press: Two-speed jet pump runs on low speed
2nd press: Two-speed jet pump runs on high speed
3rd press: One-and Two speed jet pumps run on high speed
4th press: One-speed jet pump runs on high speed
5th press: Both jet pumps are off.
Cascade and Cumberland TM Spas only:
1st press: Two-speed jet pump runs on low speed
2nd press: Two-speed jet pump runs on high speed
3rd press: Jet pump off
• During filter cycles or when the thermostat is calling for heat, the pump’s low speed operates automatically and cannot be turned off by pressing the
Temp Plus (+) or Temp Minus (–) touch pad.
• The pump on high speed automatically turns off after operating for one hour. The pump on low speed automatically turns off after operating for one hour.
• When the jets are active, the JETS LED on the control panel will illuminate.
LIGHT CONTROL
Your Highland spa is equipped with a low-voltage spa light. Press the LIGHT button to turn it on. Press it a second time to turn it off. For your spa enjoyment, a blue and
a red lens cover have been included with the spa’s owner’s packet. The original clear lens is not removable – the red or blue colored lens can be snapped over the clear
lens to create the desired ambiance.
The light automatically turns off after six hours.
When the light is active, the LIGHT LED on the control panel will illuminate.
OPERATING INSTRUCTIONS
Set Temperature
Display
Filter
Cycle LED
Jets
LED
Light
LED
Temperature
Minus
Temperature
Plus
Jet
Button
Light
Button