Cal Spas 2006 Portable spas, Руководство пользователя

Страница: 18 / 96

Operating Your Spa
Page 14 2006 Portable Spa Owner's Manual
LTR20061000, Rev. A
5200 Electronic Control Operation
Figure 5. 5200 Electronic Control
Initial Start up
When first powered up, the 5200 system (Figure 5) performs a self-diagnostic check, runs at high speed for two
seconds, and then switches to low speed to heat to and maintain 100°F (37.8°C) until you change the set
temperature as described below.
Temperature Adjustment
Range 80°F to 104°F (26.7°C to 40°C)
The electronic control panel displays the actual water temperature in degrees Fahrenheit.
To display the temperature that the spa is set to:
•
Press the “Temp” button. The set temperature setting will flash.
•
While the display is flashing, each time you press the “Temp” button, the set temperature will increase or
decrease by one degree.
Letting the display revert back to the actual water temperature, then pressing the “Temp” button again will
allow you to change the direction of temperature adjustment.
Standard and Economy Modes
Your new spa is equipped with a heating feature that gives you complete control of the heating system. When
the spa is powered up, it will automatically start in the standard heating mode. In this mode, the heating system
will automatically activate whenever the water temperature drops more than one degree below the set
temperature. In the economy-heating mode, the heating system will only activate during filtration times.