2
Select unit.
Press and hold
✱
and use the
▲
or
▼
buttons to
scroll through the unit selection list
until the correct unit is displayed.
Release the buttons.
The display will now alternate
selected unit (eg.
UNIT
and
°C
).
Press
▲
once
The display will now alternate
SP1.D
and
nonE
3
Select SP1
(Main setpoint output device)
Note:
Dual Relay and Dual SSd Output Options
Models 3311/9311 and 3322/9322 have
their outputs pre-configured. (see page 22)
Press and hold
✱
and use the
▲
or
▼
buttons to select
SSd
or
rLY
as required. The controller
will now alternate selected output device
(e.g.
SP1.D
and
SSd
).
Quick Start
QUICK START
1b
4
To enter initial configuration into controller
memory
Press and hold
both
▲
and
▼
buttons for 3 seconds. The
display will now alternate
ParK
and
measured variable (temperature)
(eg.
23
)
ParK
is displayed
because a setpoint has not yet been
entered.
To display setpoint
Press and hold
✱
The display will now alternate
0
and
unit
(eg.
°C
)
To enter setpoint
Press and hold
✱
and use
▲
button to increase or
▼
button
to decrease the reading and scroll to
required setpoint value. (The digit roll-over
rate increases with time).
THE CONTROLLER IS NOW OPERATIONAL
WITH FACTORY SETTINGS
Note:
For precise control of an application the controller
may need to be TUNED. Please study section
headed FUNCTIONS and OPTIONS before moving to
the section on AUTOTUNE.
